If you continually beat the tar out of the truck, failure is inevitable REGARDLESS of tuning; stock or otherwise. Heck, I've seen stock transmissions in stock-tuned trucks bite the dust at 50K miles. I've seen originals go 300K or more with aftermarket tuning as well. It really depends on how the truck is treated, used, and maintained.
When (not if) your transmission fails is only a matter of time and NOTHING short of driving habits and maintenance (and that's iffy as well) will help prolong the life of these transmissions.
Everybody says a lot of things on the internet. We (me included) don't know everything, but while the internet is full of good information, there is twice as much bullcrap. Heck, once one of these "internet forum facts" starts running rampant, it takes very little time for everyone to start regurgitating it as gospel. Look at the bad reputation the Edge Evolution has.....and it's all crap thanks to it's little brother the Juice Module. It's up to peoples' better judgment to stop these "facts" in their tracks. That's one reason I go on regular hiatuses (yep that's the actual term) from all of these forums....I can't take the misinformation that continually spews from people who have NO BUSINESS discussing anything other than what brand of oil filter Wal-Mart uses when they get their oil changed. I really begin to take it personally and I need a break before I ....uh....break stuff.
I'm not targeting you one bit Mike, but: "Would i be able to get a chip that wont kill my stock tranny?"
We certainly don't design ANY calibrations to purposely make your transmission live a shorter life than it would "un-tuned". Nobody wants their truck to fail prematurely but as I was preaching earlier, stock transmissions fail regardless. For all intents and purposes, if you drive sanely, the transmission friction elements SHOULD live a longer life due to the reduced slip-time between shifts. The longer a shift takes to complete, the longer the friction elements (clutches and bands) slip before finally gripping at 100%. There isn't a lot of friction material there and it takes very little cumulative slippage to glaze the friction material and steel mating surfaces resulting in a toasted transmission.
I'm simply getting to the point here. I'm not mad, upset, frustrated, or otherwise perturbed. This is just information.....straight to the point.
Last edited by cleatus12r; 08-02-2011 at 10:19 PM.
|
08-02-2011, 05:11 PM
Linear Mode
