Cadash
Tue, July 7th, 2009, 11:24 PM
Hey everyone. Im trying to use my FU software and burn my chip. I select the calibrations I want and when I go to select "click to program module" it comes back with a "the page cannot be found" error. So I hit ok and there is another window behind it.The other screen that has popped says "expanding data file, expanding calibration one" and the progress is stuck at 0%. I hit cancel and it does nothing. Now on the FU page, I select utilities, and select diagnostic data, it gives me a"Error, communications time out" at the bottom of the FU screen. LOST.......Help!!
Cadash
Wed, July 8th, 2009, 12:12 AM
Well compliments of my Black Berry doing a hard reset my phone shut off!! Its lucky its not halfway to the back yard right now!! But....my chip has been reprogrammed!! Just wasnt seated right in the burner I guess. All is good!! I thank you guys both very much. Oh.....and I figured out were the skunk smell was coming from!!! Its ME!!! I havent showered yet and Im wearing bug spray!!
On to the other issue!!!:doh:
Cadash
Wed, July 8th, 2009, 12:23 AM
You should have heard Bill.
"What's wrong, Hon?"
"I just lost Dan. He was there, and then he was just gone."
"Just call him back."
"I tried. :confused: Now I can't get through."
Glad you're up and running! Take a :shower: and get some :nitenite:!
That would be GREAT......I just purged a bunch of air out of my fuel system so I think I might be getting somewhere. I miss my truck!!!!