Where did YOU mount your 6 pos switch???

[mkf350]

Just curious where everyone has mounted there 6 position switch, hopefully with pics but not necessary..

[Diesel Rookie]

I put mine on the left side of the steering wheel centered under the headlight switch. It is very low profile and that is what I wanted.

I had to take the fuse block off it's mounts to run the switch wire and mount it back up when I was done but it was not that much work and I think it was worth it.

I will try to send a picture later

Joe

[Peroni]

I put mine here, very easy to reach and change w/o having to look away from the road.

http://www.oldengine.org/members/lozzi/images/misc/switch.jpg

[Big Bird]

mine is hanging from the trailer brake controler, havn't gotten around to drilling the hole in the dash yet. Give me some time, it only took me 1 1/2 years to finally install my gauges in the truck...:doh:

[Orezona]

Can't tell you. It is in stealth mode :giggle:

[majek5]

Between the headlight switch and the front/rear tank switch. Fits like a glove, and if you weren't lookin you would not see it.

[Big Bird]

Between the headlight switch and the front/rear tank switch. Fits like a glove, and if you weren't lookin you would not see it.

dang, yours must be smaller than mine... :yikes2:

I don't think mine would fit there. :cool:

[sam8]

Mine is down low in the lower panel to the left of the steering wheel, I just used the hole from my old 3-step chip form Bill way-back-when.
I am going to move it though. This is giving me some good ideas.

[ChuckD]

OBS FTW.:giggle:

[Power Hungry]

I like that, Chuck. Very nice!

[ChuckD]

Thanks Bill, its easy to reach and kinda concealed.