error 150 help quick :)

[97Fone50]

i need help truck wont run right programmer wont see the PCM got any thought on fixing this....

[88Racing]

Cody,
It may be Kevin?
:shrug:

[cleatus12r]

Sorry!! I was busy answering two phone calls while juggling some information for Bill since he was outside programming a 6.0L.

You're right.

[97Fone50]

Ok.... this is kevin im trying to do Firmware update there now but it says the firmware and Calibrations will not work together... what do i do i have to go outta town tomorrow!!

[Longshot270]

97Fone50, when the programmer and everything is "On" but without the engine running, disconnect the programmer. Wait about 10 seconds and plug it back in. If you hex code shows up you should be good, if not then get back to us or try calling PHP.

Kevin, can you do one update at a time like the firmware then the calibrations? Also are you just updating canned calibrations or are you downloading custom tunes? If it is just canned then dont worry about them and just focus on the firmware.

[97Fone50]

well from what im told from my brother who was the one driving he started the truck in a middle of a load of a Custom tune. He called you guys and you said i had to update the firmware now after that ..... he said the truck wont get over 10 mph. he said PHP told him to flash it back to stock.... witch is what its sittin on now

[Longshot270]

Was the return to stock successful? Does it drive like a normal stock vehicle now?

Try just the firmware update. But only if the truck is running normal.

Haha, just noticed that 97Fone50 is kevin. Sorry about that :doh: :hehe:

[97Fone50]

he told me it went back to stock lol... didnt think much about it now i tryed doing update but it failed i just went out and it just programed back.. perfect... runs good :> thanks guys

[Longshot270]

Ok, so everything is good now?

[88Racing]

well from what im told from my brother who was the one driving he started the truck in a middle of a load of a Custom tune. He called you guys and you said i had to update the firmware now after that ..... he said the truck wont get over 10 mph. he said PHP told him to flash it back to stock.... witch is what its sittin on now

:doh:

You had better have a discussion with your bro.
"Hands Off" is what I'd tell him.

[Jackpine]

I agree - Brothers should not be allowed near trucks! (I think you may have dodged a bullet.)

[Longshot270]

I agree - Brothers should not be allowed near trucks! (I think you may have dodged a bullet.)
Yeah, wouldn't the old pegasus have steam rolled over it and reset everything even though the programmer was still locked?