eabrust
Fri, May 21st, 2010, 10:34 PM
I know you can buy a gauge that specifically taps into the ICP sensor output so that the HPOP pressure can be monitored, but does anyone know, is ICP an available PID value that could be displayed with a Gryphon (assuming it was a feature in the Gryphon firmware)?
Thanks
Eric
DoneDunIt
Sat, May 22nd, 2010, 11:18 AM
The ScanGaugeII will read it. Mine runs over 800 at idle and about 1600 under a load. Have seen over 1900. Some things that the ScanGaugeII is suppose to read does not work on mine.
Maybe the firmware will get updated so that you can read it on the Gryphon. Call Edge and tell the it works on the ScanGaugeII and tell them to get on the ball.
eabrust
Mon, May 24th, 2010, 08:32 PM
Thanks for the confirmation it is a readable value.
Bill, do you have enough control over the 'Gryphon's' firmware to add anymore PIDs to monitor (or have any influence w/ Edge to ask them about adding new PIDs)? I can think of a few PIDs that would be nice for trouble shooting times (HPOP/ICP pressure, FICM volts, etc), and thats something I'd even be willing to pay for as an upgrade (Microsoft charges for upgrades all the time, right? :rofl:)
regards,
eric