DTC Code Help

[BigSur]

My emmision system light came on today. My Gryphon is throwing the following code: P0020 - Intake Camshaft / Position Actuator Circuit / Open (Bank 2).

Any ideas on what may be going on here. Had to replace a battery this week....not sure if it's relative or not.

[88Racing]

My emmision system light came on today. My Gryphon is throwing the following code: P0020 - Intake Camshaft / Position Actuator Circuit / Open (Bank 2).

Any ideas on what may be going on here. Had to replace a battery this week....not sure if it's relative or not.

Your altenator may be out the door also.....one of the diodes for the charging cycle in the altenator might be toast and can cause this code.....get the altenator tested

[BigSur]

Your altenator may be out the door also.....one of the diodes for the charging cycle in the altenator might be toast and can cause this code.....get the altenator tested
Okay sounds good. This is one of many things that have gone wrong recently. Might be trading the truck soon, so we'll see. Thanks for the reply.

[88Racing]

Okay sounds good. This is one of many things that have gone wrong recently. Might be trading the truck soon, so we'll see. Thanks for the reply.

Its best to find a shop that can use a scope to test it while running....when the dioides start to go the voltage fluxuates and some of the know voltages for certatain sensors aren't there and trigger the codes....

Unfortunately remanned alternators have their diodes overlooked when being rebuilt...the best replacement is a new oem one.....

[BigSur]

Hey 88, I noticed something weird today. Turned a corner, went light on the accelerator, and noticed a slight hesitation with the engine.....sort of "bogged" and then picked back up a few seconds later. Do you think this could be in any way relative to my emmisions light coming on, associated DTC code, etc???? I have plans to get it all checked out....just waiting to get freed up at work.

[88Racing]

Clean the maf and tb.....

[BigSur]

Clean the maf and tb.....
Actually, that is getting done with my 60k service. I know how to do it as well and will do it myself next time. How often and/or how many miles do you recommend in b/w tb and maf cleaning?

[88Racing]

I'm anal about it being every 15-20k when the fuel filter is changed.....

[BigSur]

thanks

[BigSur]

Just an update. Took my truck in today to get 60k service done....fuel filter, TB and MAF clean, tranny flush, etc. Even though I wasn't quite ready for the service, I took it in early to have the DTC code checked out....plus I had a screw in one of my tires.

Right before I walked in to drop off the key, I switched back to stock. When I did, it cleared the code....no more check engine light!!! Crazy. Good to go though.

[88Racing]

Congrats......you just cleared the code and forced the truck to do the relearn readiness test.(p1000)....now the pcm will start counting the occourances again and the code will/might come back...

[BigSur]

Ah!...gotcha. Well that sucks b/c the problem is probably still there. I guess as long as the truck is running okay, I'll leave it be. Might call my mechanic and give him the code directly though so he can check it out the next time it's in there.