Visit dYgYtAl Radio!
|
|
|
Visit dYgYtAl Radio! |
|
|||||||
| AutoEnginuity® Diagnostic Software If you have a question or a comment about the AutoEnginuity® Diagnostic Software, post it here. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
08-27-2010, 10:48 PM
|
|||
|
|||
Upgraded to 8.3 and now no oil temp?
So, I just downloaded and installed the 8.3 upgrade and then connected to my truck to see if there were any new features. The only thing I noticed that was different was that I can no longer see engine oil temp. The volt input works fine so I think the sensor is ok.
Has anyone else experienced this? If so, is there a way to get this reading back? 
|
|
09-02-2010, 12:15 PM
|
|||
|
|||
|
Problem resolved-update
Update:
I called AE and they suggested that I update the firmware on the Proline connector. The update can be downloaded from their website. Since I have the USB version, I was able to plug the Proline connector to my laptop while it was on AC power and did not have to connect to the vehicle. Oil temp works now.
|
|
| Thread Tools | |
| Display Modes | |
|
|
|
Linear Mode
