[Cadash]

Hey everyone. Im trying to use my FU software and burn my chip. I select the calibrations I want and when I go to select "click to program module" it comes back with a "the page cannot be found" error. So I hit ok and there is another window behind it.The other screen that has popped says "expanding data file, expanding calibration one" and the progress is stuck at 0%. I hit cancel and it does nothing. Now on the FU page, I select utilities, and select diagnostic data, it gives me a"Error, communications time out" at the bottom of the FU screen. LOST.......Help!!

[Groovy Chick]

Pick up the phone! I'd complain that it's too late at night to be on the phone, but we're all obviously awake.

[Cadash]

Well compliments of my Black Berry doing a hard reset my phone shut off!! Its lucky its not halfway to the back yard right now!! But....my chip has been reprogrammed!! Just wasnt seated right in the burner I guess. All is good!! I thank you guys both very much. Oh.....and I figured out were the skunk smell was coming from!!! Its ME!!! I havent showered yet and Im wearing bug spray!!

On to the other issue!!!

[Groovy Chick]

You should have heard Bill.

"What's wrong, Hon?"
"I just lost Dan. He was there, and then he was just gone."
"Just call him back."
"I tried. Now I can't get through. I don't know what happened..."

Glad you're up and running! Take a :shower: and get some !

[Cadash]

Originally Posted by Groovy Chick

You should have heard Bill.

"What's wrong, Hon?"
"I just lost Dan. He was there, and then he was just gone."
"Just call him back."
"I tried. Now I can't get through."

Glad you're up and running! Take a :shower: and get some !

That would be GREAT......I just purged a bunch of air out of my fuel system so I think I might be getting somewhere. I miss my truck!!!!