added UD pulley's, need to change anything?
hey bill and corey,
i just added UD pulleys, is there anything i need to change? like idle speed or anything? thanks |
Yes, go into CO and bump the idle up 50-75 rpms. With everything on you don't want to fall below 13.0 volts on the voltage pid.
Lars |
Damn, Lars, you're good. :cool:
|
ok thanks, i set it at 65.
is that all? also i dont know if anybody can help out about this but the gryphon is showing i have 2 DTC's 1. P0480 Fan 1 Control Circuit 2. P0528 Fan Speed Sensor Circuit No Signal i dont get where i would check for this, i have the harness connected that connects to the fan and there is nothing else unplugged any ideas? |
I don't know what to check either. Sounds like the system thinks you have e-fans, but you don't show that you do. I don't think there's any kind of monitoring for the clutch driven fan.
- Jack |
Quote:
Make sure all connections are tight. Check to make sure there isn't a magnetic pickup sensor on the old waterpump pulley. I haven't dealt w/ to many 2008's yet. Lars |
ok i will try clearing them. im positive there is only one connection to the fan and it is plugged in.
also there wasnt anything on the water pump, but i will make sure there is nothing around it |
Quote:
|
Quote:
Better description than what I had to offer! Lars |
Quote:
Lars |
All times are GMT -5. The time now is 08:53 AM. |
All Contents Copyright 2008-2020, Power Hungry Performance