Dieselsite HPOP
Last time I talked to bill he was talking about doing some testing/tuning with bob and was going to post some results on the new HPOP they offer. Any updates on this bill? I am pretty tempted to get one because I want the extra kick for pulling my 5er. but 500 is a bit hard to come by at the moment...
|
Bill's finishing up the F.U. software tonight so that he can have it tested, but he'll be on the forums tomorrow, and I'll be sure that he pops in :surprise present: on this thread. I know he's been doing a ton of stuff with Bob Riley (he was actually up here last month and Bill played with his truck for the day), but as for what they've come up with... well, I just work here and look cute. :ugly dude: :hehe:
|
Quote:
Bill's tunes changed the way my truck runs completely. I now can make use of the improved HPOP. I have also seen a significant improvement in fuel mileage since installing PHP's chip. Previously my best mileage was 12.8-13.1 since installing Bill's tunes I have averaged 14.3-14.8 over the last 2500 miles. Barney 02 F550 Tow Bully |
I have a adrenaline pump also and my F250 went from 14.5 mpg towing a 14ft enclosed trailer and equipment to about 16.7 from Raleigh to Charlotte. (about 180 miles). Im have to replace the wiring harness on my ICP so my truck is down right now. I spoke to Bob Riley about 30 min ago and he suggested I check out Bill for some tuning. Anyone know where I can get the wiring harness for the ICP without going to the dealer? Thanks :2thumbs:
|
I don't but I'm sure a Google search would yield results. There's several Ford places that sell on the internet for below "dealer cost".
- Jack |
This might sound dumb, but I know that through GM (yes, GM), you can very cheaply get a connector for for a throttle position sensor that is the exact same as the ones we have for the ICP and EBP sensors...for less than $20. It will include the connector and about 10" worth of wire on each lead. If you'd like, I will get a part number today and you can go into any GM dealer and order the part. I'll get the part number anyhow and post it up here.
|
I got mine from the local IH truck dealer $12 incl tax. I just asked for the icp connector for a T444 engine. FYI ebp sensor uses same connector.
|
The AC Delco part number is 88988301.
|
Thanks for info!! Ill keep you guys posted on if that fixes the old girl.
|
Hey Bill - Any updates on the pump? What all did you find out when playing with Bob?
|
All times are GMT -5. The time now is 11:50 AM. |
All Contents Copyright 2008-2020, Power Hungry Performance