Originally Posted by JackandJanet (Post 39559)

Cajunboy - please read this "sticky" in the FAQs for Gryphon programmers: http://forum.gopowerhungry.com/faqs-...ions-menu.html

The "zero" values are all "baseline" settings that represent what Bill has programmed for your tune. Please pay particular attention to what is said about "placeholder" values for Tire Size (TS) and Gear Ratio (GR).

A +1.5 setting on the timing would be appropriate for an octane increase of 3 points over what has been set up in your current tune.

- Jack

Originally Posted by cajunboy2208 (Post 39552)

I am going to mess with the timing and stuff.
I loaded the custom tune, and then went in the timing.
And it just says 0 on it.
I checked all of the other functions, such as shift points and stuff, they they are all not set either.
Is this normal? Yes, these are your comparative baselines
Should I still just set it on the +1.5 save it for the timing.
Not unless your are going up 3 in octane, I strongly advise against long jumps like this because even if you filled up from 87 to 93 you still have the old 87 in the lines and a few gallons mixed throughout the tank.
And then next time it loads it will be set back to 0? Or will it be at 1.5 now?
Very confused on that.
The baseline will always be what Bill has it set at, to have the changes carry over you MUST go to "retreive previous settings" or something along those lines. It should be the last option on the list.

Also. I did notice that my gear ratios is set to 3.73
I have 3.55 gears... was wondering if this is an error or did Bill accidenty insert 3.73 for me?
When I revereted it back to stock, it read the correct 3.55 gears, so this naturally worried me that he might of inserted the wrong value, and now my odometer is all effed up.
No, the 3.73 is a placeholder value. Because of these placeholder values you cannot just "check" so see what the real number is set to.

Not sure if I was clear on all of that.
I just figured it would already have values set in the custom tune instead of everything being at 0...
If all Bill did was change those numbers in the custom options menu then he wouldn't be much of a custom tuner. :giggle:

Originally Posted by cajunboy2208 (Post 39566)

I did read it, I just didn't quite understand it.
And still... when I increase the "baseline" setting. Will this become the new "baseline"?No Or will whatever I increase it to show up and not be at 0? Like I said, this is the reasoning for the recall previous settings or whatever it is named by.

Originally Posted by cajunboy2208 (Post 39696)

ok that cleared most of it up.
Just to be sure, leave the gear ratio to 3.73?

I got 1/2 tank of gas left before I start editing the custom tunes.

Originally Posted by JackandJanet (Post 39712)

Now, the NEXT time you decide to use the Custom Options menu (after this one), IMMEDIATELY scroll to "Load Previous Settings" and hit [enter] just as soon as you open the menu! This will reset all the values you've customized into the appropriate places. If you want to change anything, you do it AFTER "loading previous settings"!

- Jack