View Single Post
  #3  
Old Mon, February 22nd, 2021, 12:49 PM
Power Hungry's Avatar
Power Hungry Power Hungry is offline
The Godfather of Power Stroke Tuning
 
Join Date: Nov 2008
Location: Winder, GA
Posts: 2,458
Power Hungry has much to be proud ofPower Hungry has much to be proud ofPower Hungry has much to be proud ofPower Hungry has much to be proud ofPower Hungry has much to be proud ofPower Hungry has much to be proud ofPower Hungry has much to be proud ofPower Hungry has much to be proud of
Default

Pretty nice looking.

Suggestion... I'd make the back end height adjustable. Sleeved box with set bolt. That also would allow for different bellhousing/mounting options by making a new upper section. This also helps when setting the angle of the engine so that the carb is level.

I'm sure you going to put some large casters on it. It's nice to be able to roll that sucker out of the way.

Here's a couple videos of the 289 on the Easy Run engine stand. After looking at what all the materials and components would cost, I decided it would just be easier to buy one that to build one from scratch. As much fun as it is to fabricate stuff, it really comes down to available time to actually get anything accomplished.

Anyway, enjoy.

1) 2)

3) 4)
__________________
Bill Cohron - The Mad Doctor

Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1996!
(678) 890-1110

www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar!

Bring back Windows™ XP and 7.
Windows™ Vista and Windows™ 8 is a pain in my a$$!
Windows™ 10 is only slightly less annoying!
Reply With Quote