View Single Post
  #4  
Old Wed, February 3rd, 2021, 07:26 PM
cleatus12r's Avatar
cleatus12r cleatus12r is offline
F Your Yankee Blue Jeans
 
Join Date: Jan 2009
Location: Somewhere in Montana
Posts: 3,063
cleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to all
Default

More pictures just for the heck of it!

Oil pan depth fix.

Reluctor for vehicle speed sensor. Crown Vic had one mounted in the transmission; pickup transmission had no provision so math was my friend for mounting a pickup to the rear differential. I rebuilt the rear end while I had it apart. Stock 3.08:1 gears. This is a 39 tooth drive sprocket for a Polaris snowmobile that I cut the center out of and then drilled/tapped to bolt to the yoke flange on the rear end. Mid-2000s GM truck front wheel speed sensor is the pickup.

Starter clearance in RH crossmember.
Oil filter clearance in LH crossmember.
Steering shaft modifications to clear engine.
Turbine discharge pipe (downpipe).

Oh, and the OEM replacement (gasoline) fuel pump works a treat!
Attached Images
File Type: jpg 20170213_114927.jpg (1.43 MB, 6 views)
File Type: jpg 20170220_155809.jpg (1.76 MB, 8 views)
File Type: jpg 20180416_174308.jpg (313.6 KB, 7 views)
File Type: jpg 20180429_180636.jpg (381.5 KB, 10 views)
File Type: jpg 20180128_124818.jpg (377.6 KB, 5 views)
File Type: jpg 20180128_124839.jpg (363.4 KB, 5 views)
File Type: jpg 20180129_202550.jpg (319.2 KB, 5 views)
File Type: jpg 20180129_202619.jpg (290.4 KB, 5 views)
File Type: jpg 20180406_124554.jpg (239.2 KB, 6 views)
Reply With Quote