Whatever you do, you'll have to match your inferred table to the output voltage of your sensor. If the sensor only reads 3.8v at WOT, then the table should reflect that. If it's reading 4.4v at WOT, it should again reflect that. This way you can make the most use out of your pedal travel.
__________________
Bill Cohron - The Mad Doctor
Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1996!
(678) 890-1110
www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar!
Bring back Windows™ XP and 7.
Windows™ Vista and Windows™ 8 is a pain in my a$$!
Windows™ 10 is only slightly less annoying!
|