![]() |
|
Gryphon Programmer Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
i need help truck wont run right programmer wont see the PCM got any thought on fixing this....
|
#2
|
||||
|
||||
![]()
Cody,
It may be Kevin? ![]()
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
#3
|
||||
|
||||
![]()
Sorry!! I was busy answering two phone calls while juggling some information for Bill since he was outside programming a 6.0L.
You're right.
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
#4
|
|||
|
|||
![]()
Ok.... this is kevin im trying to do Firmware update there now but it says the firmware and Calibrations will not work together... what do i do i have to go outta town tomorrow!!
|
#5
|
||||
|
||||
![]()
97Fone50, when the programmer and everything is "On" but without the engine running, disconnect the programmer. Wait about 10 seconds and plug it back in. If you hex code shows up you should be good, if not then get back to us or try calling PHP.
Kevin, can you do one update at a time like the firmware then the calibrations? Also are you just updating canned calibrations or are you downloading custom tunes? If it is just canned then dont worry about them and just focus on the firmware.
__________________
|
#6
|
|||
|
|||
![]()
well from what im told from my brother who was the one driving he started the truck in a middle of a load of a Custom tune. He called you guys and you said i had to update the firmware now after that ..... he said the truck wont get over 10 mph. he said PHP told him to flash it back to stock.... witch is what its sittin on now
|
![]() |
|
|