|
Minotaur Automotive Tuning Software Tune your own 7.3L Diesel! If you have a question or comment about Minotaur? Post it here. Also, check out our Facebook group: Facebook - Minotaur Tuners |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Error Problems
When I try to erase all 6 positions on the chip, the first position takes about 1 minute, then it says Make sure you in position 2, when I click OK, the burner makes a beep immediatly, then says make sure you are in position 3, the same thing happens from there until the 6 position afterwards I get this error message...
"ERROR: Module Not In Position 6" I tried it a few times, with no luck. I d/ced everything(power cord first ), then the usb, then pulled the chip, then pulled the switch off the chip, restarted the computer. No change After wards I figured maybe the chip is already erased, so I went ahead and tried to program the chip, It burned the first position, then it said make sure you are in position 2, I selected the file, and then it said "module not erased". Am I doing something wrong? I am using windows vista home(I don't think the 64 bit version, but I could be wrong). |
#2
|
||||
|
||||
Billy's calling ya in a few minutes.
__________________
~ Corey Resting in Peace - 1969 - 2019 |
|
|