THEFT light blinking after install - Page 2

RobbyMartin · #11 Thu, February 25th, 2010, 08:16 AM

Quote:

Originally Posted by XPerties

Just a shot in the dark but since you removed a power source maybe when you hooked the battery back up it reset.

Have you tried to program back to stock and then reprogram back to your custom tune?

I did an engine swap going from a 4.6 to a 5.4 and Bill wrote a stock for the truck to think it was a 5.4 then he wrote the custom tunes for the 5.4. So the stock tune is also written by Bill.

XPerties · #12 Thu, February 25th, 2010, 08:23 AM

Quote:

Originally Posted by RobbyMartin

I did an engine swap going from a 4.6 to a 5.4 and Bill wrote a stock for the truck to think it was a 5.4 then he wrote the custom tunes for the 5.4. So the stock tune is also written by Bill.

Stock/custom tune for 4.6 to think it's a 5.4 - Did this have the PATS disable setup?

Custom/Custom tune for 5.4 - Had the PATS disabled (correct)?

.........OR did they "BOTH" have PATS disabled?

and just because I need to know, why would you ask for the PATS to be disabled? It's one of the best security features out there?

RobbyMartin · #13 Thu, February 25th, 2010, 07:08 PM

Quote:

Originally Posted by XPerties

Stock/custom tune for 4.6 to think it's a 5.4 - Did this have the PATS disable setup?

Custom/Custom tune for 5.4 - Had the PATS disabled (correct)?

.........OR did they "BOTH" have PATS disabled?

and just because I need to know, why would you ask for the PATS to be disabled? It's one of the best security features out there?

Bill disabled the PATS in all modes...Stock and Custom.

The BOZO mechanic that put the engine in did some shady work and now my truck won't start so I had the PATS disabled in the event that he screwed it up. Once I find out what why it's not starting and it fires up and it's not a PATS issue then I'll have Bill enable it again.