![]() |
|
1999 to 2003 7.3L Power Stroke Diesel 7.3L Power Stroke Diesel equipped Super Duty and Excursion |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]()
I am in the middle of installing a pheonix chip on my '01 powerstroke and I've got a bit of a problem. When I was tightening down my PCM Connecter, I over tightened it
![]() ![]() ![]()
__________________
Jon B. '76 f100 4x4, 390 BB '78 f100 2x4, 300 straight 6 '01 f250 4x4, 7.3L, 6spd. '03 expedition, 5.4 v8 04 mustang, 3.9L v6 |
#2
|
||||
|
||||
![]()
You will need something to hold the connector in the PCM firmly.
Take the PCM to a shop and have the bolt extracted, unless you have experience doing this I would not attempt this. Good Luck. |
#3
|
||||
|
||||
![]()
Ok I got it out. I just took some bolt cutters and cut off the head of the bolt and then I was able to pull it out and go get another bolt to fit it. I was a little unsure about cutting the head off the bolt, not knowing how it was held into the harness, but it has a washer on the inside and the head on the outside that holds it all together. Once I cut the head off the bolt, it all came apart and the new bolt just slid right into place.
__________________
Jon B. '76 f100 4x4, 390 BB '78 f100 2x4, 300 straight 6 '01 f250 4x4, 7.3L, 6spd. '03 expedition, 5.4 v8 04 mustang, 3.9L v6 |
![]() |
|
|