|
|
|||||||
| 6.0L PSD FICM Reprogramming Power Hungry Performance revolutionized the 6.0L FICM (Fuel Injection Control Module) programming and has been the industry standard for FICM modification for almost 15 years. If you have questions or would like more information about the benefits, please post here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
Sat, September 3rd, 2011, 08:47 PM
|
|||
|
|||
FICM PROGRAMMING QUESTION
Thank you in advance for any input
Here's what I have a 2005 f350 2wd drw with a previously weak FICM sent to Swamp's for a 58 volt upgrade and mild FICM programming. ECM/TCM was sent to PHP for roll back while vehicle was down. Requested non inductive heat strategy for FICM. Swamp's recommended to have inductive heat strategy installed so I agreed. Current strategy VXCF4N3, TQCION3, PRZ2AL11. Now my question, did I make the right choice (performance and economy minded)? I currently live in Virginia with ranging weather and cold starts have yet to be a concern for me. I am truly after performance, is there a ficm strategy that will perform better (offering more power/economy, power 1st)? Thank you for everyone's time 
__________________
Oh well
|
|
#2
Thu, September 8th, 2011, 08:45 PM
|
|||
|
|||
Thank you for the reply Groovy Chick. I spoke to Jonathan prior to having the FICM being shipped back to me. I was advised it was a PHP FICM program installed with inductive heat. I was curious is there would be any performance gain from a non inductive heat strategy/program?
Thanks again
__________________
Oh well
|
|
|
|
Linear Mode
