|
6.0L PSD FICM Reprogramming Power Hungry Performance 6.0L FICM (Fuel Injection Control Module) programming has been the industry standard for in FICM modification almost 10 years. If you have questions or would like more information about the benefits, please post here. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
An Article about Bill's 6.0L FICM Reprogramming
Check this out!
6.0L Power Stroke FICM Reprogramming from Power Hungry Performance: Gain Mileage and Performance
__________________
~ Corey Resting in Peace - 1969 - 2019 |
#2
|
|||
|
|||
I read this on FTE before seeing it here. I wish I still had my 6.0 liter because it was a much more fuel efficent vehicle than my 6.4.
|
#3
|
||||
|
||||
Quote:
- Jack
__________________
2014 F150 Platinum SCrew 3.5L EcoBoost 4x4 with SCT programmer |
#4
|
|||
|
|||
I read the article, thats how I found this forum,. I have a 04 PSD that got new heads under warranty a year ago (and a PCM reset), and was at the shop again for a wiring harness warranty repair thus summer, and again the invoice says "reset PCM". To be honest I dont know if it runs worse - it always seems to run fine. Over time I kept adding goodies and never got a real good MPG baseline. Would I see improvement if got my FICM reset to the original factory setting , or are these not related ? I get 14-15 mpg with my SCT on the 100 HP setting, so I cant complain.
Thanks, Tom |
#5
|
|||
|
|||
so what would be the approx turn around time on a ficm to Canada?
|
#6
|
||||
|
||||
FICM Shipping to Ontario
Quote:
Hope that helps.
__________________
~ Corey Resting in Peace - 1969 - 2019 |
#7
|
||||
|
||||
Tom,
Most folks would see an improvement, especially in conjunction with a programmer although even a stock truck would see noticeable gains. 14-15 with an SCT still seems a little low for mileage, but then again I don't know how you drive or what you use the vehicle for. If you consistently pull a load or drive aggressively, then you're probably about where you'd expect. If you run empty and drive conservatively, you would probably expect to see some gains. As for turnaround time to Canada? How much do you feel like spending? Unfortunately, shipping to Canada is all about money. The faster you want it, the (exponentially) more it's going to cost you. My time 1 day. What you have to decide is whether what you'll spend in reprogramming and shipping is going to pay itself off in performance and/or fuel savings. Take care.
__________________
Bill Cohron - The Mad Doctor Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1996! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back Windows™ XP and 7. Windows™ Vista and Windows™ 8 is a pain in my a$$! Windows™ 10 is only slightly less annoying! Last edited by Power Hungry; Sun, December 28th, 2008 at 06:21 PM. |
#8
|
|||
|
|||
Quote:
Thanks! |
|
|