DTC Code Help

BigSur · #1 Thu, December 1st, 2011, 11:30 AM

My emmision system light came on today. My Gryphon is throwing the following code: P0020 - Intake Camshaft / Position Actuator Circuit / Open (Bank 2).

Any ideas on what may be going on here. Had to replace a battery this week....not sure if it's relative or not.

***88Racing*** · #2 Thu, December 1st, 2011, 11:39 AM

Quote:

Originally Posted by BigSur

My emmision system light came on today. My Gryphon is throwing the following code: P0020 - Intake Camshaft / Position Actuator Circuit / Open (Bank 2).

Any ideas on what may be going on here. Had to replace a battery this week....not sure if it's relative or not.

Your altenator may be out the door also.....one of the diodes for the charging cycle in the altenator might be toast and can cause this code.....get the altenator tested

BigSur · #3 Thu, December 1st, 2011, 05:01 PM

Quote:

Originally Posted by 88Racing

Your altenator may be out the door also.....one of the diodes for the charging cycle in the altenator might be toast and can cause this code.....get the altenator tested

Okay sounds good. This is one of many things that have gone wrong recently. Might be trading the truck soon, so we'll see. Thanks for the reply.

***88Racing*** · #4 Fri, December 2nd, 2011, 12:17 PM

Quote:

Originally Posted by BigSur

Okay sounds good. This is one of many things that have gone wrong recently. Might be trading the truck soon, so we'll see. Thanks for the reply.

Its best to find a shop that can use a scope to test it while running....when the dioides start to go the voltage fluxuates and some of the know voltages for certatain sensors aren't there and trigger the codes....

Unfortunately remanned alternators have their diodes overlooked when being rebuilt...the best replacement is a new oem one.....

BigSur · #5 Mon, December 5th, 2011, 07:03 PM

Hey 88, I noticed something weird today. Turned a corner, went light on the accelerator, and noticed a slight hesitation with the engine.....sort of "bogged" and then picked back up a few seconds later. Do you think this could be in any way relative to my emmisions light coming on, associated DTC code, etc???? I have plans to get it all checked out....just waiting to get freed up at work.

***88Racing*** · #6 Mon, December 5th, 2011, 07:06 PM

Clean the maf and tb.....

BigSur · #7 Tue, December 13th, 2011, 02:24 PM

Just an update. Took my truck in today to get 60k service done....fuel filter, TB and MAF clean, tranny flush, etc. Even though I wasn't quite ready for the service, I took it in early to have the DTC code checked out....plus I had a screw in one of my tires.

Right before I walked in to drop off the key, I switched back to stock. When I did, it cleared the code....no more check engine light!!! Crazy. Good to go though.

***88Racing*** · #8 Wed, December 14th, 2011, 11:22 AM

Congrats......you just cleared the code and forced the truck to do the relearn readiness test.(p1000)....now the pcm will start counting the occourances again and the code will/might come back...

BigSur · #9 Wed, December 14th, 2011, 08:22 PM

Ah!...gotcha. Well that sucks b/c the problem is probably still there. I guess as long as the truck is running okay, I'll leave it be. Might call my mechanic and give him the code directly though so he can check it out the next time it's in there.