PLEASE, help with this 7.3 no start

[bo_champion]

Hello I am a new member, I have been reading post for over a month now trying to figure out my "no start" on my 2000 7.3 psd. I'm sorry for being long just want to share as much as I can. My Problems started a couple of months back with hard starting. The truck would crank over longer and longer before starting. Then about a month ago no start at all.

I had a friend hook it to a scanner and said it was not getting enough oil pressure. So I started with the ICP (No Help) then IPR (No Help). I then bit the bullet and got a new HPOP, still no start.

At this point I ordered a Autoenginuity with the enhanced ford package. I recived the AE about a week ago. On my first codes were showing, P1663, P1667, P0605, P0470, P1278. After this I inspected the wiring I found some bare wires on the driver side valve cover. I repaired the wires pulled the valve covers and replaced the Glow Plugs and under the cover harnesses. I also put 2 new batteries and a new exhaust back pressure tube on. Still NO START..

I cleared the codes and ran another scan. Now I have, Powertrain: P1280, P0470, P0603. KOEO:P0605, P1266, P1268, P1276, P1278. Inj. Buzz test: all 8 buzz a couple are weak.
While cranking the truck my live data stream shows: Inj. Press. Cntrl. 287psi (with ICP plugged in) 2200psi (with ICP unplugged) this makes no sense to me. Inj. Press. Volts 55v (with ICP) 0 (w/o ICP), Fuel Injector Pulse width: .60 IPR duty cycle 31.64. RPM: 154

I am thinking maybe a bad PCM? I really hate to buy one not knowing for sure and I dont know anyone close that I could swap out with. Any and all suggestions will be a great help.