Did i fry my chip???

Cory S · #1 Sat, April 23rd, 2011, 02:33 PM

i have the FU burner and chip and have reburnt my chip 4 times with no problems. then today i went to update tunes and it says my software is out of date, so i went on and downloaded the new pheonix software. but now after i select tunes and the pop up says place in position 1, i press ok, and an error comes up that says the chip is not formated. it says check in utilities and see if the multi chip authorization s FC but mine is FF.

Cory S · #2 Sat, April 23rd, 2011, 06:51 PM

bump bump bump

ticopowell · #3 Sat, April 23rd, 2011, 07:36 PM

If this should be in the "truck wont work/emergency/stranded" section then you might expect Bill to respond on a weekend, but if it does work then they probably wont respond until monday. if it is an emergency I would call though, it would make things go quicker than waiting online.
I would try and help but I don't know anything about the FU chip or the FU2 chip. :/

***cleatus12r*** · #4 Mon, April 25th, 2011, 06:44 AM

Check your burner power relay. Over-zealous installation of the chip into the burner can dislodge the relay and cause you this exact problem.

Cory S · #5 Mon, April 25th, 2011, 01:38 PM

Quote:

Originally Posted by cleatus12r

Check your burner power relay. Over-zealous installation of the chip into the burner can dislodge the relay and cause you this exact problem.

i checked that and it is intact where is should be

***cleatus12r*** · #6 Mon, April 25th, 2011, 03:52 PM

If your relay is in fact where it should be, your switch is in the first position, and you are getting "FF" for CID, it's likely that it's fried.

Cory S · #7 Wed, April 27th, 2011, 04:35 AM

so i need to buy a new chip?

***cleatus12r*** · #8 Wed, April 27th, 2011, 10:25 AM

You can send us yours and we will tell you if it's fried or not for sure. However, if the CID says "FF" even if the switch is in position 1 and the power relay on the burner is intact, I'd say you need to buy a new chip.