injector removal question?

epowers777 · #1 Sat, January 15th, 2011, 01:20 AM

If you haven't read yet I'm having a ruff idle. I am going to pull the injectors and do an inspection then re torque everything under the valve cover( a task I read in my maint. Link) he straight it'll quiet down your 7.3. My question is since my injectors are brand new stage 2 single shots do I need to change the o rings or anything or can I just POP them out inspect the cup and injector and put them back?

StripperDJ · #2 Sat, January 15th, 2011, 06:47 AM

You may not have too but i always put new o rings and washers on the sticks anytime i have to pull them.

epowers777 · #3 Sat, January 15th, 2011, 04:43 PM

So do i get a special kit for single shots?

***907DAVE*** · #4 Sat, January 15th, 2011, 09:51 PM

If the injectors have not been in there too long you will be fine, but give them a good look over before you stick them back in.

The o-rings are all the same if you decide to change them.

SICKS-O · #5 Mon, January 17th, 2011, 09:46 AM

do not reuse the injector o rings or copper washer.