![]() |
|
Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Just got my new FICM Gryphon programmer in the mail yesterday for my 05 F-350 6.0L and I'm super happy with the performance I've seen so far.
![]() ![]() ![]() Tuner Info: Model: GPFD60F-0307 Bootloader: 2.63.4860 Firmware: 3.101302 Calibration: 2.4.1272 Hardware: 5025 |
#2
|
||||
|
||||
![]()
Try: MENU►HELP►VEHICLE INFO (I suspect you have a CS or CTS platform).
- Jack
__________________
2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam |
#3
|
|||
|
|||
![]()
Nope, I have the original monochrome Gryphon.
|
#4
|
||||
|
||||
![]()
Sorry! So, when you select Menu->Diagnostics, you only see "Retrieve DTCs" and "Clear DTCs"? You DON'T see "Data Stream Read", "Data Stream Options" and "Version Info"?
Forgive me if I sound like I'm giving you the "idiot treatment". I have a gas monochrome Gryphon and now I'm beginning to suspect your diesel version has a completely different menu structure, except, the manual for this programmer on the Edge website shows that it's not. ![]() So, try something else. Unplug your Gryphon from the truck's OBD port. Then, turn the ignition ON (but don't start the truck) and plug the Gryphon back in. You are supposed to see a logo (boot screen) followed by a disclaimer that your have to dismiss by pressing [Enter]. Right after you do that, you SHOULD see your truck's ECM and TCM "hex" codes displayed. Write them down before you press [Enter] again. And just so you know, you DON'T have to set your truck back to stock before you do this. You can remove and reattach the Gryphon from your truck at any time while it's acting as a monitor. - Jack |
#5
|
|||
|
|||
![]()
Jack, thanks for the suggestions but unfortunately my tuner isn't working how you describe. I get the flash screen at start up, I do not get the disclaimer as described, and it only displays the FICM strategy before I press enter. And you are also correct in that I don't see "Data Stream Read", "Data Stream Options", and "Version Info" under Diagnostics. I'm starting to wonder that since the programmer is set up to work with the FICM that it doesn't talk to the ECM/TCM and therefore doesn't give me the option to pull their strategies. I may have to get Bill to help me switch the Gryphon to the normal ECM diesel tuner before I see those options unless someone else can think of something I'm missing.
![]() |
#6
|
||||
|
||||
![]()
James, I agree - you're going to have to talk to Bill about this. I'm totally out of ideas. I see that your <a rel="nofollow" href="http://forum.gopowerhungry.com/profile.php?do=editprofile" target="blank">User Profile</a> is complete. I'll try to draw Bill's attention to this thread, but you should try to call them too.
Edit: I've posted a note for Bill in the moderator's forum. - Jack |
Tags |
ecm/tcm strategy, gryphon tuner |
|
|