More ?'s

[907DAVE]

Originally Posted by cleatus12r

The cold idle control and the cold idle multiplier are the ones you want.

It appears the values for the multiplier are in seconds, could this be the amount of time it takes to pick up the high idle?

Bill actually set up one of the definitions to display the actual RPM you want the engine to run at after a specific time.

That might be pretty handy.

I used that function on my PMT1 files (originally-purchased definition) with no issues before, but I was using the emulator at the time to get the RPM right where I wanted it.

I have played with it a bit using the emulator (which BTW has not left the PCM in a few months), and the changes seemed to take a very long time to respond. I need to play with it a bit more when temps drop a few more degrees to see what its going to do.