NewB Question? - Page 2

x2mosg · #11 Thu, September 23rd, 2010, 05:25 PM

I don't have pics of my guts, but mine is black where yours is light grey. The rest looks the same except the flow-through console. And I think the a/c vents in mine are chrome, but to be honest i'm not sure, guess I should pay more attention. Duh!!

This is what I get with my VIN. This is the top section of hte console, with the drink holders in the back and the hinged lid attaches to it. The "Warm Steel" is the color.

Part Number
Part Description
Price
Your Price
Availability
Quantity

<04567
Console Cover Panel
All Flow Thru Floor Consoles ; Warm Steel Finish $147.95 Add to cart

I found a couple of posts earlier, but didn't have time to get them linked in here. I'll try to do that now.

David

x2mosg · #12 Thu, September 23rd, 2010, 05:51 PM

This post has a little, but not much help:
http://forum.gopowerhungry.com/gryph...yphon-pod.html

Some more information here:
http://forum.gopowerhungry.com/gryph...int-pod-2.html

Little more here:
http://forum.gopowerhungry.com/gryph...estions-2.html

I'm bout to go to Advance Auto to see if they can offer any help. Good bunch of folks at my local store. I'll report back later.

David

x2mosg · #13 Thu, September 23rd, 2010, 06:01 PM

For chits and giggles I looked again on fordparts.com and found this PDF file. Might be of some help to us all.

http://www.fordparts.com/FileUploads...file/paint.pdf

David

***Longshot270*** · #14 Thu, September 23rd, 2010, 09:09 PM

Thanks x2mosg, I just got back on the computer and was about to go hunting for them.

x2mosg · #15 Thu, September 23rd, 2010, 11:18 PM

No Sweat. I gotta find this stuff for myself, so might as well share.

My Int/Trim code is QB. That gives me 2 colors according to the chart in the PDF file above, Black and Charcoal Black. I assume the Charcoal Black is the trim pieces, even though they're otherwise called Warm Steel.

Here are a couple of pics:

David

LonestarROB · #16 Fri, September 24th, 2010, 08:39 AM

Ya know, it my be the black throwing off the eyes, but I think the pod will match up pretty well with yours.

x2mosg · #17 Fri, September 24th, 2010, 09:34 AM

Yeah I think the black is decieving, and maybe that 1/2" layer of dust on everything. Been planting greens/food plots the last few weeks. Boy it's dusty here. The grey is actually pretty dark. I'd bet it's within a shade or two of yours. Frustrating part is we're getting 2 or 3 different color choices from Ford even. Looks like a trial and error thing short of getting a custom color match type thing.

x2mosg · #18 Fri, September 24th, 2010, 10:04 AM

Just found this place. Looks pretty promising. Not cheap, but promising. I don't have a local place to mix custom rattle cans, so I'm limited. Small town.

Touch up Spray Paint, Spray Cans, Spray Paint, Car Paint, Automotive Paint by DuPont, R-M, SEM and 3M @ TouchupSprayPaint.com

LonestarROB · #19 Fri, September 24th, 2010, 02:57 PM

Played around with my paints and old dash pod. Tried the Dark flint(which it should be says Ford) and again too light. Tried putting it over black base coat. Tried other gray paints. Tried spraying Dark flint and black at the same time

. Then smacked it across garage with nearby hammer.

x2mosg · #20 Fri, September 24th, 2010, 03:15 PM

If it can't be fixed with Duct Tape or a ball-pean hammer, it can't be fixed! I wasted some money on a can of Duplicolor charcoal grey last night, and a waste it was. Not even close.

I ordered a custom rattle can from the link above. It ain't cheap, so I hope it works.