|
|
|||||||
| Gryphon Programmer Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
Thu, February 19th, 2009, 08:53 PM
|
|||
|
|||
Quick Re-flash question
im getting ready to send my edge into you guys for an upgrade, but while the edge is away im taking my truck into the shop because i think somethings wrong with my tranny (shutters when shifting from 1st to 2nd, and sometimes 2nd into 3rd). I am returning the truck back to stock, but will it effect anything if they have to reflash my computer? I didnt know if the edge saves a code or anything?
|
|
#2
Thu, February 19th, 2009, 08:59 PM
|
|||
|
|||
|
I think that's is why they say to return to stock so they don't don't overwrite your tuning. If they reflash the HEX code is the same they just change the stock programming parameters. Others may respond that are more knowledgeable.
|
|
#3
Fri, February 20th, 2009, 12:15 AM
|
||||
|
||||
|
Before sending in the unit for upgrade, let the dealer do what they need to and when they are done make sure you reconnect the unit and at least read the HEX code. Otherwise, it's possible that we will build any custom files using the old calibration and they may end up being incorrect.
For best results, do a full programming session and then return to stock. This way, the PCM data will be stored in the unit and we can extract it when we receive it.  Take care.
__________________
Bill Cohron - The Mad Doctor   Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1996! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back  Windows™ XP and 7.  Windows™ Vista and Windows™ 8 is a pain in my a$$!  Windows™ 10 is only slightly less annoying!
|
|
|
|
Linear Mode
