|
|
Visit dYgYtAl Radio! |
|
|||||||
| Phoenix™ Switch-On-The-Fly Chip If you have a question or a comment about the Phoenix multi-position module, post it here. |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
If you stand on it itll kind of shift up then back down real fast and it lurches real bad. I hate how it barks the tires on the shifts anyone who rides with me thinks my trans is going out. It does that in 80DD and 100 perf when your get over about 2300 RPMs. I want smooth shifts. In 100 perf. it will take off thru 1st and 2nd like there is no chip then it hits 3rd and I'm gone. Is there any tune that will give me power in 1st and 2nd? I almost got beat by a stock 6.0 until I hit 3rd. 100 is my highest tune. I dont really use 80DD or my low idle so I have 2 spaces I would be able to use.
|
|
|||
|
I dont have the guys name, I wish I did. Maybe I can look thru some stuff and find it. I am pretty sure the truck only has the torque converter and I dont know what kind it is.
|
|
||||
|
Quote:
__________________
2000 F250 CC/SB 4X4 7.3L, ISSPRO GAUGES, TS 6 POSITION CHIP, DIY CAI, 4.5in STRAIGHT PIPED DUMP INFRONT OF REAR TIRE, TQ LOCK UP, EBPV MOD, FOIL DELETE
|
|
|||
|
Any info on this problem, I just installed my Phoenix and same exact problem lurching/bucking going into 3rd
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|
|
|