|
|
Visit dYgYtAl Radio! |
|
|||||||
| Phoenix™ Switch-On-The-Fly Chip If you have a question or a comment about the Phoenix multi-position module, post it here. |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
Howdy,
I have had my chip installed now for a week. And so far so good. Not getting as much smoke as i wanted, but its a lot more then stock ![]() I got stock 25 tow 65 tow 80 DD 120 Race 120 SS The truck doesnt really run that great in the Smoke Show setting, has a goofy idle and rattles when driving a lot more then I think it should. But I wont use it much at all once the new wears off of it. I put it in my 2003 F-250 CC LB 4x4 Auto. I pull a lot with this truck, it hauls grain and pulls my antique pulling tractor around the country. I usually gross about 26K with my tractor and while hauling grain it will gross 41K, but thats only 6 or 7 mile trips at 35 to 40 mph. I have gutted the turbo, and welded the waste gate shut, have open 4inch exh, open air filter, new intercooler boots, AIH delete added a fuel pressure guage, along with all the other guages Truck had 127K miles and the only problems i got, is it has a vibration from 25mph on up, and I cant find it, been that way since I bought it 15K miles ago Think its trans, or t-case, or maybe a weight off a drive shaft![]() But other then that everything is great. except fuel milage, it hasnt gotten any better, but we'll see what happend when the new wears off ![]() I'll keep ya updated. |
|
|||
|
Seems like it takes awhile to wear the new off these doggone things...lol
__________________
2000 F-250 SCLB 2wd 7.3 auto PHP stock-65t-80dd-120race-high idle-no start 4"tb exh, wicked wheel, 3 guages, AIS, coolant filt, |
![]() |
| Thread Tools | |
| Display Modes | |
|
|
|
|