Power Hungry Performance Forum - THEFT light blinking after install

Page 2 of 2

Show 100 post(s) from this thread on one page

Power Hungry Performance Forum (http://forum.gopowerhungry.com/index.php)

- Gryphon Programmer (Disabled) (http://forum.gopowerhungry.com/forumdisplay.php?f=7)

- - THEFT light blinking after install (http://forum.gopowerhungry.com/showthread.php?t=3315)

RobbyMartin

Thu, February 25th, 2010 09:16 AM

Quote:

Originally Posted by XPerties (Post 25839)

Just a shot in the dark but since you removed a power source maybe when you hooked the battery back up it reset.

Have you tried to program back to stock and then reprogram back to your custom tune?

I did an engine swap going from a 4.6 to a 5.4 and Bill wrote a stock for the truck to think it was a 5.4 then he wrote the custom tunes for the 5.4. So the stock tune is also written by Bill.

XPerties

Thu, February 25th, 2010 09:23 AM

Quote:

Originally Posted by RobbyMartin (Post 25920)

I did an engine swap going from a 4.6 to a 5.4 and Bill wrote a stock for the truck to think it was a 5.4 then he wrote the custom tunes for the 5.4. So the stock tune is also written by Bill.

Stock/custom tune for 4.6 to think it's a 5.4 - Did this have the PATS disable setup?

Custom/Custom tune for 5.4 - Had the PATS disabled (correct)?

.........OR did they "BOTH" have PATS disabled?

and just because I need to know, why would you ask for the PATS to be disabled? It's one of the best security features out there?

RobbyMartin

Thu, February 25th, 2010 08:08 PM

Quote:

Originally Posted by XPerties (Post 25922)

Bill disabled the PATS in all modes...Stock and Custom.

The BOZO mechanic that put the engine in did some shady work and now my truck won't start so I had the PATS disabled in the event that he screwed it up. Once I find out what why it's not starting and it fires up and it's not a PATS issue then I'll have Bill enable it again.

All times are GMT -4. The time now is 06:55 PM.

Page 2 of 2

Show 100 post(s) from this thread on one page