Power Hungry Performance Forum

Power Hungry Performance Forum (http://forum.gopowerhungry.com/index.php)
-   Gryphon Programmer (Disabled) (http://forum.gopowerhungry.com/forumdisplay.php?f=7)
-   -   Gryphon Pod (http://forum.gopowerhungry.com/showthread.php?t=2827)

97Fone50 Tue, January 5th, 2010 04:04 PM

Gryphon Pod
 
I was wondering how everyone mounted there Programmer Pod what glue 2 sided tape whatever u used i need some ideas mine aint sticking to well..

88Racing Tue, January 5th, 2010 04:12 PM

3M doulble sided accessory tape(tape is grey with red covering) same stuff as vent visor uses. Napa, auto zone, advance, and orieleys should all stock it.
I don't have your year truck or that style pod.
Just make sure you clean your dash good.

LonestarROB Tue, January 5th, 2010 04:41 PM

Mine fits tight enough that I didnt have to use anything. Although 88Racing's idea is a good one, I'd be worried about it sticking too much and messing up the dash if you were to ever remove the pod. That tape is stiiiicky. :D

97Fone50 Tue, January 5th, 2010 05:08 PM

mine fits goood i just need something sticky lol

Jackpine Tue, January 5th, 2010 06:00 PM

If you have a 97, you have the older model pod. I actually started with one of those, and while it didn't "stick" to the dash, it never really went anywhere either, due to the tension in the cable and the way it mounted.

I finally DID apply some double stick tape though, I think under the front edge of the pod just above the vent. It seemed to work better than putting it at the back of the pod (toward the front of the vehicle).

- Jack

AZFX4 Tue, January 5th, 2010 10:48 PM

I put 3m double sided tape from Walmart on mine. I put 2 strips on the side of the dashboard towards the door. I put 1 on straight part, then did a small piece where it curves. Then I put a SMALL piece on the curved part of the pod that fits inside near the gauges. I actually stacked 2 3m double sided tape so it would stick. It fits good. And it hasn't affected my dash from the 2 times I had to remove it. It wouldn't stick without any tape. Once you peel the pod off after taping it, you'll have to retape it.

97Fone50 Wed, January 6th, 2010 10:19 AM

i think a good part of mine is that its cold out side and everythings harder then a board.... lol


All times are GMT -4. The time now is 07:35 PM.


All Contents Copyright 2008-2024, Power Hungry Performance