Thread: Program won't stay programmed
View Single Post
  #2  
Old Tue, June 30th, 2009, 09:12 PM
Jackpine's Avatar
Jackpine Jackpine is offline
PHP Groupie
  
Join Date: Nov 2008
Location: Among Elk, Deer and Javalinas on the Mogollon Rim in Aridzona
Posts: 3,243
Jackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to all
Default
Quote:
Originally Posted by Mexico Dan View Post
Tried everything I can think of...I change the tire size and gear ratio, but nothing changes. I go back in to see the numbers and they go back to 2550 and 3.55. I've loaded previous settings, same thing. I even followed the instructions Bill gave me over the phone. Any ideas?
Are you sure you're allowing the settings you've put in to be "programmed"? Once you set all the numbers you want, scroll to "Done". Then push <Enter> and the programmer will spend about the next three minutes programming your PCM. Let it do this to completion.

If you hit the <Menu> button after you put in the numbers you want, and even if you've scrolled to "Done", you will "back out" of the custom options menu and you won't save anything (or program anything).

- Jack
__________________

2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam