Thread: F1 code
View Single Post
  #5  
Old Sat, November 27th, 2010, 10:51 AM
Jackpine's Avatar
Jackpine Jackpine is offline
PHP Groupie
  
Join Date: Nov 2008
Location: Among Elk, Deer and Javalinas on the Mogollon Rim in Aridzona
Posts: 3,243
Jackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to all
Default
Red, I doubt you were "flashed" - The error code 0xF1 can sometimes appear during programming. Try this:
1. Leave the ignition key in the ON position.
2. Disconnect the Gryphon at the OBDII port.
3. Plug the Gryphon back into the OBDII port.
4. After getting to the main screen, wait 15 seconds for needed parameters to be loaded.
If you still cannot program the PCM successfully, contact PHP for assistance.

I THINK your programmer simply did not boot properly after you got your truck back from the dealership.

AND - please insure your battery is fully charged and that both the truck and the Gryphon are "warm" (now that cold weather is here).

- Jack
__________________

2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam