It shouldn't hurt. Any small carbon particles will blow right through before the turbo even gets moving. Just don't load the manifold up with chemicals. If you need to use solvent, use just a little bit and then start the vehicle to allow the chemicals to blow out.
You can also check for a clogged EBP tube by removing the sensor and cranking the vehicle up. You should feel a noticeable pressure at idle.
Good luck.
__________________
Bill Cohron - The Mad Doctor  
Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997!
(678) 890-1110
www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar!
Bring back  Windows™ XP and 7. 
Windows™ Vista and Windows™ 8 is a pain in my a$$! 
Windows™ 10 is only slightly less annoying! 
Windows™ 11 is garbage! 
Much to my surprise, I'm actually quite enjoying Linux! 
|