Wed, February 3rd, 2021, 08:26 PM
|
 |
F Your Yankee Blue Jeans
|
|
Join Date: Jan 2009
Location: Somewhere in Montana
Posts: 2,659
|
|
More pictures just for the heck of it!
Oil pan depth fix.
Reluctor for vehicle speed sensor. Crown Vic had one mounted in the transmission; pickup transmission had no provision so math was my friend for mounting a pickup to the rear differential. I rebuilt the rear end while I had it apart. Stock 3.08:1 gears. This is a 39 tooth drive sprocket for a Polaris snowmobile that I cut the center out of and then drilled/tapped to bolt to the yoke flange on the rear end. Mid-2000s GM truck front wheel speed sensor is the pickup.
Starter clearance in RH crossmember.
Oil filter clearance in LH crossmember.
Steering shaft modifications to clear engine.
Turbine discharge pipe (downpipe).
Oh, and the OEM replacement (gasoline) fuel pump works a treat!
|