Quote:
Originally Posted by jerodr
Well...I was washing my truck earlier and I got in it to turn it around in my driveway, cranked it and an "Engine in failsafe mode" beeped on my message center. Scared the Sh** out of me. So I turned it off and checked the dtc codes on my gryphon. It pulled one - P2106: Throttle Actuator Control System - Forced Limited power. So I thought ok i'll just return it back to stock and see what happens. Did that and now I have a different code only - P1000 On-Board Diagnostics System: Readiness Test not complete. The "engine in failsafe mode" isn't on anymore, but I am still getting this code. I unpluged the gryphon and plugged it back in but the code is still there. Any help would be greatly appreciated.
Jerod
|
Check this. It's quite possibly related to your issue.
http://www.ford-trucks.com/tsb/fullt...p?tsb=05-18-12
As for the P1000, that is completely normal and should go away after some normal driving, although it may take up to a couple days to make it go away.
If the P2106 occurs again, shut the truck off, restart, and then go into the diagnostics menu and clear the DTCs. This should clear everything out.
Hope this helps.
__________________
Bill Cohron - The Mad Doctor
Power Hungry Performance - The
ORIGINAL in Ford performance tuning... Since 1997!
(678) 890-1110
www.gopowerhungry.com - Home of the
Hydra Chip,
Minotaur Tuning Software, and the new
Orion Reflash System for Navistar!
Bring back
Windows™ XP and 7.
Windows™ Vista and
Windows™ 8 is a pain in my a$$!
Windows™ 10 is only slightly less annoying!
Windows™ 11 is garbage!
Much to my surprise, I'm actually quite enjoying Linux!
