|
|
|||||||
| 1997 to 2003 F-150 4.2L, 4.6L, and 5.4L equipped F-150s. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Mon, July 20th, 2009, 11:27 AM
|
|||
|
|||
I'm doing the PI head swap
I am have swapped the stock 98 heads for the Romeo PI heads and the matching intake. From what I have been reading in forms everywhere I am going to need a Gryphon to run right. Rose racing pistons and scat h-beams. I think it will be about 10.6 compression but am going to shave the big bump out of the combustion chamber so will lower the compression a bit more. I have the Shorty headers "Pacesetter" and am staring at the cats wondering if I should chop them off. My question is ..Has someone here done something like this and what can I expect
|
|
#2
Mon, July 20th, 2009, 04:38 PM
|
||||
|
||||
|
Wow! Heck of a question. I imagine Bill might have some ideas on this, and, I suspect he will enjoy working on it. You need to get in touch with him.
- Jack
__________________
 2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam
|
|
#3
Mon, July 27th, 2009, 12:55 PM
|
|||
|
|||
 I thought that was what the form was for.More mustang mods than truck I guess but it had a bent con rod when I bought it so you have to rip them apart and put it back together better than it was.very funny scotty now beam down my cloths
|
|
|
|
Hybrid Mode
