![]() |
|
F.U. Chip & FU2 Flex Chip (DISCONTINUED) (Disabled) If you have a question or comment relating the new F.U. Chip or FU2 Flex Chip, post it here. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Just curious where everyone has mounted there 6 position switch, hopefully with pics but not necessary..
__________________
2002 F-250 CrewCab LB AFE ProGuard 7 intake 4" Magnaflow ss exhaust with 4" downpipe BTS Trans Valvebody Dieselsite Adreneline HPOP Garret GP38R turbo PHP Phoenix FU |
#2
|
|||
|
|||
![]()
I put mine on the left side of the steering wheel centered under the headlight switch. It is very low profile and that is what I wanted.
I had to take the fuse block off it's mounts to run the switch wire and mount it back up when I was done but it was not that much work and I think it was worth it. I will try to send a picture later Joe
__________________
4" Down pipe and exhaust, Wicked Wheel, Modified Exhaust Turbo Housing, Big Head Waste Gate Actuator, PML Transmission Pan, Factory Tech Valve Body, Autometer Gage Pod, PHP FU2 Chip |
#3
|
||||
|
||||
![]()
I put mine here, very easy to reach and change w/o having to look away from the road.
![]()
__________________
the ![]() ![]() |
#4
|
|||
|
|||
![]()
mine is hanging from the trailer brake controler, havn't gotten around to drilling the hole in the dash yet. Give me some time, it only took me 1 1/2 years to finally install my gauges in the truck...
![]() |
#5
|
|||
|
|||
![]()
Can't tell you. It is in stealth mode
![]() |
#6
|
||||
|
||||
![]()
Between the headlight switch and the front/rear tank switch. Fits like a glove, and if you weren't lookin you would not see it.
|
|
|