Sold My Gryphon and

svt2205 · #1 Thu, March 17th, 2011, 08:56 PM

I'm looking to see if I can, well you guys, can help out the new owner of my Gryphon. I returned the tuning to stock before selling my old truck. Then I ran the updates to purge the custom tune and restore the unit to it's canned state.

Now the new owner is getting this error, "checksum failed RXAP9B6" when he tries to load #2.

Any suggestions? I've not had any issues with the unit during the 2 or so years I had it. And I want the new owner to be happy with his purchase.

Please help
Thanks

svt2205 · #2 Thu, March 17th, 2011, 09:18 PM

More info, as provided by the new owner. The truck has 35's and the speedo reading is correct. It's probably been tuned and not returned to stock.

What, if anything, can be done?

kobra_commader · #3 Thu, March 17th, 2011, 09:40 PM

Quote:

Originally Posted by svt2205

More info, as provided by the new owner. The truck has 35's and the speedo reading is correct. It's probably been tuned and not returned to stock.

What, if anything, can be done?

im the new owner.... please help me!!

svt2205 · #4 Thu, March 17th, 2011, 09:54 PM

Someone will help, I'm sure of it.

Hey, what's that black 87-93 Mustang?

ticopowell · #5 Fri, March 18th, 2011, 01:57 AM

I am no expert by any means, but I would first try to reload the canned tunes again, they may have been messed up a little. If that doesnt work then load the second most up to date update, it should be still available. sometimes there are little updates that forget certain trucks from what I have seen... but like I said that is just my thoughts, and I wont be surprised if they aren't 100% correct...

hope that helps

kobra_commader · #6 Fri, March 18th, 2011, 02:33 PM

ok well i tryed to update it and it did (firmware and calibration updates)

i was prompted to unplug it and plug it back in.. and i did

when i pluged it back in i got a warning that said "device must be restarted...unable to locate valid calibration hex info..

then it tells me to reboot it by unpluging it and pressing menu and pluggin back in

i did this and it did reboot and went to the warning screen

then it tells me to unplug it and plug it back in and to press ok to restart the update process... but when i press ok after doin so it says the gryphon is not found (and the gryphon screen is green)

wtf did i do?!