Power Hungry Performance Forum  

Go Back   Power Hungry Performance Forum > Power Hungry Performance Product Information > Phoenix Switch-On-The-Fly Chip (DISCOUNTINUED) (Disabled)

Phoenix Switch-On-The-Fly Chip (DISCOUNTINUED) (Disabled)
Power Hungry no longer sells the Phoenix/TS chip, but if you need custom tuning we can recommend a few really good tuners that will be able to still provide tuning and support for your chip.

If you have any other questions or comments about the Phoenix/TS chip, please post it here.


 
 
Thread Tools Display Modes
  #1  
Old Wed, March 7th, 2012, 09:59 PM
yngbuck19 yngbuck19 is offline
Whopper
 
Join Date: Feb 2012
Posts: 19
yngbuck19 is on a distinguished road
Default Fast shipping

Very happy with how quick my Phoenix chip got here bravo!
I removed and cleaned my PCM tonight going to try it out soon after I get my efuel back together and PCM back in.

I took the PCM covers off and I only used paper towels Qtips and a little alcohol to get the initial greasy stuff off and took out the 5x glass to inspect and there was alredy some copper showing so I took my finger nail and used it to scrape the silicone off both sides and polished with the scotchbrite cleaned with alcohol two times with Qtips and sealed it back up lightly tightened cap screws inserted chip with switch connected.
  #2  
Old Thu, March 8th, 2012, 08:11 AM
yngbuck19 yngbuck19 is offline
Whopper
 
Join Date: Feb 2012
Posts: 19
yngbuck19 is on a distinguished road
Default

Would it help to put any dielectric grease on the J3 connector should I be concerned with the tiny bit of copper showing but the chip still goes on tightly.

Those are my two questions right now
  #3  
Old Thu, March 8th, 2012, 08:53 AM
cleatus12r's Avatar
cleatus12r cleatus12r is offline
F Your Yankee Blue Jeans
 
Join Date: Jan 2009
Location: Somewhere in Montana
Posts: 2,658
cleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to allcleatus12r is a name known to all
Default

DO NOT put anything on the contacts.

As long as you use a piece of tape to hold the chip in (don't stretch the tape or make it tight...just enough to hold the chip in), you shouldn't have an issue.
  #4  
Old Thu, March 8th, 2012, 07:01 PM
yngbuck19 yngbuck19 is offline
Whopper
 
Join Date: Feb 2012
Posts: 19
yngbuck19 is on a distinguished road
Default

Thanks for the reply I'll probably use some heat tape from work it won't leave any residue and is super sticky.
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 05:13 PM.


All Contents Copyright 2008-2024, Power Hungry Performance