Power Hungry Performance Forum  

Go Back   Power Hungry Performance Forum > Ford - All Other Vehicles (Disabled) > 1994 to 2020 Ford Cars

1994 to 2020 Ford Cars
All OBD-II vehicles go here. Mustangs, T-Birds, Cougars, Taurus SHOs, Contours, Focus, Mark-VIIIs, GTs, and anything else you can think of will be right at home.

If you have questions about late model cars or just have a nice one to brag about, here's the spot for you, too!


Reply
 
Thread Tools Display Modes
  #1  
Old Sun, August 26th, 2012, 05:01 PM
ticopowell's Avatar
ticopowell ticopowell is offline
Grown-up in training!
 
Join Date: Oct 2009
Location: Currently in Tampa FL
Posts: 863
ticopowell will become famous soon enough
Default Clutch problem

Ok, Question for anyone that knows anything about my mustang, details of the car are listed in my sig.
The car's clutch has been acting weird, sometimes it feels like it isn't engaging/disengaging. A few times while I have been driving it, right after I start the motor I can't get the car into gear, any gear, with the clutch pedal pushed to the floor. About 3 other times I tried to start the car, the clutch was in all the way, and the the car started moving when the starter motor was engaged.
Both times it acted like I wasn't pushing the clutch in.
All I could do to fix the first scenario was to turn off the car, pump the clutch(this didn't appear to fix anything as far as I could tell), and then start it in gear. The problem starting in gear hadn't happened yet, so I didn't think to not put it in gear.
In the cases where it started moving I stopped the starter, pulled it out of gear, and it started right up and went into gear without issue.

Any ideas?
I would think it was low clutch fluid, but it still engages and disengages normally most of the time. Actually brought the car to the drag strip in san antonio, best time of 14.5, and it had it's problems once there, but we got it working again pretty quickly.
Could it be the slave cylinder or something related? The clutch and flywheel are about 6 months old now, I didn't replace the slave cylinder then, I didn't realize at the time that it was recommended to do, so does that make sense that it should be replaced?
Other than either of those two ideas, I have no idea what could be wrong, so any help, or guesses, or ways to save me money, would be appreciated.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:14 AM.


All Contents Copyright 2008-2024, Power Hungry Performance