|
Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Cylinder head temp Q
Hey guys!
.......what is normal CH temp? I have not yet shown this in my display but I am going to shortly and want to know what I should be looking for! I assume it varies a fair bit from cruise, WOT and while towing say 2-3000lbs? Also, does anybody know how much higher the CH temp would be if your were running a little too lean at cruise (like say 15.9:1 or 16.0:1). thanks, Chris
__________________
08 FX4 CREW K&N 63 series Intake Magnaflow SI/DO exhaust Custom tunes |
#2
|
||||
|
||||
I've seen around 215 to 235 on average, which translates to about 195 on the ECT. ECT is actually inferred from CHT so you can use either value.
At cruise, there is very little load so temp shouldn't be too far out of line, even when slightly lean. Where you need to be concerned is under moderate to heavy loads. At this point, it's not so much how high the temps get, but how fast they change. A 25 degree rise in temp over a couple minutes is not a huge deal when under a moderate load, but 25 degrees in 30-60 seconds could indicate excessive cylinder temps. Hope this helps.
__________________
Bill Cohron - The Mad Doctor Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back Windows™ XP and 7. Windows™ Vista and Windows™ 8 is a pain in my a$$! Windows™ 10 is only slightly less annoying! Windows™ 11 is garbage! Much to my surprise, I'm actually quite enjoying Linux! |
#3
|
||||
|
||||
gotcha.........thanks Bill.
good to know!
__________________
08 FX4 CREW K&N 63 series Intake Magnaflow SI/DO exhaust Custom tunes |
|
|