|
|
|||||||
| Phoenix Switch-On-The-Fly Chip (DISCOUNTINUED) (Disabled) Power Hungry no longer sells the Phoenix/TS chip, but if you need custom tuning we can recommend a few really good tuners that will be able to still provide tuning and support for your chip. If you have any other questions or comments about the Phoenix/TS chip, please post it here. |
|
|
Thread Tools | Display Modes |
|
#2
Tue, August 9th, 2011, 10:46 PM
|
||||
|
||||
I'm going to go out on a limb here because it seems like most everyone does this at some point or another but never pays attention when putting the thing back together; like all of the pieces don't need to be there or go back together a certain way.......
 The detent washer was installed with the tab in the wrong hole. Take off the knob, the nut, and the star washer. Then remove the detent washer. Turn the switch shaft fully counterclockwise and then reinstall the detent washer with the tab in the hole labeled as "6". Reinstall the star washer, nut, and knob. VOILA!!!
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim. |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode