I just got a 2002 7.3L Crew Cab! :D

[907DAVE]

If you have never done them before, should take an hour or two.....but if you have the help of someone who has.....under an hour from start to finish.


Couple tips:

• Be sure to mark the shafts before you bang the old joint out, this way it stays balanced.
• Grease zerks always point towards the driveline.
• Pay very close attention when installing the caps, one needle bearing that "falls down" will ruin your day.
• Be sure to "burp" the joint if they are tight after installing the clips. This is done by striking the driveline near the joint with a hammer. They should move freely without any tight spots.
• When greasing the newly installed joints, make sure grease comes out of every cap.
• Patience, patience, patience.

Good Luck!