|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Wed, June 3rd, 2009, 10:06 AM
|
||||
|
||||
At lunch before you put it back to stock see what codes are in the diagnostics. Then put it back to stock to see if it still happens.
1. Check and clean battery terminals if needed. Check cable ends. 2. May be starting to have issues with throttle body? Picture in your avatar is small on the blackberry so I was just guessing? Lars
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
|
#2
Wed, June 3rd, 2009, 10:18 AM
|
||||
|
||||
|
okay went out to the truck to check the diagnostics and came up with this code. I cleared the codes turned on the truck again and the same code came back. "Throttle petal position sensor / Switch f Circuit high"
|
|
#3
Wed, June 3rd, 2009, 10:44 AM
|
||||
|
||||
|
Quote:
P2135? P2106? If its the TPS its a common thing for them to go out. The good side is you still have drivability for now. But post to still see what happens in stock to confirm/narrow down trouble shooting. Lars
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
