help

[88Racing]

Read through the gryphon Q+A also

Lars

[PoisonXA]

i just wanna know what you guys have done while you wait. like for instance where to put the shift points and firmness and etc etc i just wanna know what you guys have done.

[Jackpine]

Originally Posted by PoisonXA

i just wanna know what you guys have done while you wait. like for instance where to put the shift points and firmness and etc etc i just wanna know what you guys have done.

What WE have done will not be right for you.

But, IF you use level 3 and IF you fill with 93 octane, you should be able to add +1 degree of timing. You may want to set your 1-2, 2-3 WOT shift points at or near 5000, and the 3-4 WOT shift point around 4500. Set the Max RPM to 5400.

Some people like to increase the shift firmness, I didn't. Those that do seem to use around +10 for 1-2 and 2-3 and around +6 for 3-4.

Stresses on the 3-4 shift are the highest, so don't be aggressive on that one.

I reduced my part throttle up and downshift speeds and TC lock/unlock points to save gas. You might want to do the same or increase yours to improve on part throttle power.

And, as Lars said, read through the "Custom Options Q & A" too. You'll find it here: http://dygytalworld.ehost-services13...ead.php?t=1101

- Jack

[PoisonXA]

Originally Posted by JackandJanet

I reduced my part throttle up and downshift speeds and TC lock/unlock points to save gas. You might want to do the same or increase yours to improve on part throttle power.



- Jack

What did you set it to to, save gas?

[Jackpine]

I simply set the upshift/downshift speeds to -2, -3 and -5 and the TC Lock/Unlock speeds to -2, -3, -5 and -10.

Both of these are also dependent on throttle position, so the effect is they happen at lower speeds when the throttle input is low.

- Jack