That's the "drive cycle not complete" code. Usually, it shows up after returning to stock or disconnecting the battery. There IS a way to reset it (very complicated) and it's in the FAQs on PHPs website, but it should go away by itself after you drive the truck a few times.
You also might be able to clear it now using the Gryphon. It's in one of the menus, I think under Diagnostics.
- Jack
__________________
2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam
|
Mon, July 27th, 2009, 12:15 PM
Threaded Mode