|
|
|||||||
| Minotaur Automotive Tuning Software Tune your own 7.3L Diesel! If you have a question or comment about Minotaur? Post it here. Also, check out our Facebook group: Facebook - Minotaur Tuners |
 |
|
|
Thread Tools | Display Modes |
|
#1
Thu, September 17th, 2009, 03:24 PM
|
|||
|
|||
Switch question
When the switch is unplugged from the chip while it is installed on the pcm what position does it run? Does it default to position 1? or does it act like the chip isn't installed?
Thanks. 
|
|
#2
Thu, September 17th, 2009, 06:40 PM
|
||||
|
||||
|
Position 1; you are correct.
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory!
|
|
#3
Thu, September 17th, 2009, 06:44 PM
|
|||
|
|||
|
Thanks. I had thought thats what it did but wasn't sure.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
