Replacement PCM programming

[Power Hungry]

Absolutely. It'll only take a minute to read the PCM and push everything into the replacement unit. Just let me know when you have plans to be down this way and we'll get it taken care of.

[mr.c]

Bill: I have a 2004 Powerstroke 11/03 build. The dealership has flashed away most of my towing power. I bought a spare FICM a while back and had you reprogram it. Better but nowhere near what it was. If I bought a spare PCM and sent it to you along with another FICM, could you flash it back to what I bought in a new truck? Original power and economy. Engine braking in tow/haul. I am not looking for a powerhouse that will compromise the head gaskets. Just the power that it had before Ford flashed it all away. The FICM that I had you flash has the inductive heat flash. You had mentioned a while back that you were going to reflash those with a different strategy. Are you doing those now?
Also, after installing the FICM that I had you flash, The truck has shown an incompatability code.
Last question: If I buy another PCM, does it need to be from a 2004 or can it be earlier or later build?
I did read here that you need the existing information on the current PCM.

[Power Hungry]

If you send in a PCM and FICM, we can reprogram them with the original, as-built calibrations. Some of the later PCM flashes have been extremely weak, particularly on the '05 and up.

You shouldn't have any problem using the later FICM hardware and in fact is all you can buy new from the dealer at this point.

Let me know if you have any other questions.